No, only a combination of Lampe Berger's home fragrances with the AIR PUR System 3C® method of diffusion guarantees the consumer quality and safety.

No, it is not intended for that. Its period of use is a maximum of one minute per cubic metre, in other words 20 minutes’ use in a 20sqm (51.60ft2) room.

Yes, provided you obey the recommendations for use and take care that they do not handle the lamp themselves and that the lamp is out of their reach. Purely as a precaution, we do not recommend using the Lampe Berger if there is a pregnant woman in the room.

Not under normal conditions of use (see instructions for use). You must simply take care that it is out of their reach, so that there is no risk of it falling over. In any case, you must place it so that it is stable.

Anywhere: living room, lounge, bathroom, kitchen, office, bedroom, corridor, entrance. The atmosphere that you will create will vary according to the choice of fragrance and room.

To clean the air by eliminating bad odours . To fragrance the air durably . To decorate the home

No, mixing fragrances can cause chemical reactions with possible formation of substances considered as indoor pollutants, in the liquid or at the instant of diffusion. The variety of the product range means you do not have do your own mixing and that you have access to seven families representative of the best sellers in the market and today's fashions.

The ideal is to have several lamps and to use a different fragrance in each one. Alternatively, simply light the burner with So Neutral for 30 minutes before switching to a different home fragrance.

This is the alcohol which best meets Lampe Berger's promises.

With a regularly use and provided it is used exclusively with LAMPE BERGER Home Fragrances, simply change the burner after every 200 lightings. (See the recommendations for the use of burner)

There are two areas in the burner of which one, the central area, preserves the nuances of Lampe Berger home fragrances.

1)If you leave the flame to burn less than 2 minutes, there is a risk that the catalysis did not start. Solution => Try again, leaving the flame to burn for 2 minutes 2)The catalysis did not start, the burner is soaked with Home Fragrance. Solution => - Take out the wick and the burner and leave it to dry for 3 hours until the wick is completely dry. - Check the lamp is filled to a maximum of 2/3rd. - Put the wick and burner back and put the cap on the lamp. - Leave the wick to soak for 20 minutes. - Light the burner and leave the flame to burn for 2 minutes or until it has reduced visibly and then blow it out. (See the instructions for use)

The cap has not been replaced on the burner, the Home Fragrance has evaporated. Solution => - Take out the wick and burner out of the lamp. - Check if there is Home Fragrance in the lamp. If not, fill it up to 2/3rd. - Replace the burner and the wick asse into the lamp - Leave the wick to soak for 20 minutes. - Light the burner normally (See the instructions for use) NB: Always put the cap back on the burner between uses.

There is no Home Fragrance left in the Lamp, OR the cap has not been replaced on the burner, the Home Fragrance has evaporated. The lamp is empty. Solution => - Take out the wick and burner out of the lamp. - Check if there is Home Fragrance in the lamp. If not, fill it up to 2/3rd. - Replace the burner and the wick asse into the lamp - Leave the wick to soak for 20 minutes. - Light the burner normally (See the instructions for use) NB: Always put the cap back on the burner between uses.

The burner was not positioned properly on the base, mainly on small lamps. Solution : - Take out the wick and burner out of the lamp. - Check if there is Home Fragrance in the lamp. If not, fill it up to 2/3rd - Replace the burner and the wick asse into the lamp - Check the burner is correctly inserted and positiioned on the base. - Leave the wick to soak for 20 minutes. - Light the burner normally NB: Always put the cap back on the burner between uses.

To create an account, you only need to click on : « your account » which you will find at the top end right of the home page and complete the application form.

To subscribe to the newsletter, you have 2 possibility :
- If you already have an account, go to your client space and click on « account information ».
- Create your client account and chose to receive a newsletter.

If you have forgotten your password, you have the possibility to ask to be send a new password.
For this, click on « I have forgotten my password » on the home page of your account. You will receive a new password by email.